Teaser: New forum is installed... ;) .....You just can't have access to it yet...
Next steps: Moving all the styling and fixes done over the past few weeks over to the new location. and then doing the data move, and then fixing the broken data
Almost, folks!

Hamspeed's Halo Fog Lights

Anything related to Car Audio, Security or Electrical issues.
User avatar
gazza1286
Posts: 446
Joined: Sun Sep 14, 2014 7:10 am
OBD2 Code Reader?: No
Location: Stockton-on-Tees

Hamspeed's Halo Fog Lights

Postby gazza1286 » Fri Aug 11, 2017 7:48 pm

Just started installing these. Looks relatively simple.

The only issue is the module block which bridges the existing loom to the new fog lights. Where is the best place to mount it? I'm reluctant to drill into the vertical members either side of the radiator and think that using cable ties may be the best option.

Any advice?

User avatar
MisterK
Posts: 826
Joined: Tue Apr 05, 2005 7:50 pm
OBD2 Code Reader?: No
Location: North Warwickshire

Re: Hamspeed's Halo Fog Lights

Postby MisterK » Sat Aug 12, 2017 9:02 am

I just used a cable tie and connected it to one of the struts holding on the crash bar from what I can remember. They're not heavy so don't need a lot of support, they just need to be secure. Hope this helps.
MARK K - Original Owner/ 'Best In Class' winner, 'Show n Shine', MR2DC National Event 2017. :D

User avatar
gazza1286
Posts: 446
Joined: Sun Sep 14, 2014 7:10 am
OBD2 Code Reader?: No
Location: Stockton-on-Tees

Re: Hamspeed's Halo Fog Lights

Postby gazza1286 » Sat Aug 12, 2017 1:27 pm

Thanks for that.

I eventually decided to get the drill out. Two self-tappers on the outboard face of the vertical members. All done -
What an amazing improvement. The originals were wrecked and Mr T wanted £75 each.

Thank you Hamspeed!


Return to “Audio / Security / Electrical”

Who is online

Users browsing this forum: No registered users and 2 guests